Clausing Mill - 8530
#4
Welcome Michael,
I'd be surprised if the nut was a press fit, there would be no way to align it as it was pressed in. The drawing shows a 3/8 set screw coming in from the front, would that be holding it by going into the recess.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Clausing Mill - 8530 - by mirain33 - 04-23-2016, 05:07 PM
RE: Clausing Mill - 8530 - by Mayhem - 04-23-2016, 08:16 PM
RE: Clausing Mill - 8530 - by mirain33 - 04-23-2016, 09:26 PM
RE: Clausing Mill - 8530 - by f350ca - 04-23-2016, 09:45 PM
RE: Clausing Mill - 8530 - by EdK - 04-23-2016, 09:55 PM
RE: Clausing Mill - 8530 - by mirain33 - 04-24-2016, 06:08 AM
RE: Clausing Mill - 8530 - by Mayhem - 04-24-2016, 12:36 AM



Users browsing this thread: 4 Guest(s)