04-22-2016, 06:02 AM
After getting the critical measurements from johnnyc14 (thanks again John) I drafted a precision blueprint of the dimensions:
![[Image: BluePrint.jpg?dl=0]](https://dl.dropboxusercontent.com/s/momnikpdt07uzof/BluePrint.jpg?dl=0)
There is a pulley here somewhere.....
![[Image: ThePulleyIsHereSomewhere.jpg?dl=0]](https://dl.dropboxusercontent.com/s/mfofcl2gkrzvmbx/ThePulleyIsHereSomewhere.jpg?dl=0)
I couldn't chuck the rough piece, so I drill pressed it and mounted it on a bolt to turn down one end:
![[Image: cutChunkToFit.jpg?dl=0]](https://dl.dropboxusercontent.com/s/hnhmxxan2vardr0/cutChunkToFit.jpg?dl=0)
After that I was able to chuck the piece and drill the hole to clear the boring bar that was made for this project. Boring Bar
There is a pulley here somewhere.....
I couldn't chuck the rough piece, so I drill pressed it and mounted it on a bolt to turn down one end:
After that I was able to chuck the piece and drill the hole to clear the boring bar that was made for this project. Boring Bar