|
Z axis setter gauge
|
|
04-19-2016, 03:15 PM
Thanks Dave. Actually I am a mechanical engineer but I can do drafting if I have to! I took several liberties that are not correct for an engineering drawing. But, I think my shortcuts are not too bad and it all fits on one sheet of paper and is still readable.
JScott, proud to be a member of MetalworkingFun Forum since Mar 2014.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Z axis setter gauge - by JScott - 04-19-2016, 02:57 PM
RE: Z axis setter gauge - by DaveH - 04-19-2016, 03:08 PM
RE: Z axis setter gauge - by JScott - 04-19-2016, 03:15 PM
RE: Z axis setter gauge - by Vinny - 04-19-2016, 03:15 PM
RE: Z axis setter gauge - by JScott - 04-19-2016, 03:38 PM
RE: Z axis setter gauge - by ieezitin - 04-19-2016, 03:28 PM
RE: Z axis setter gauge - by TomG - 04-19-2016, 06:55 PM
RE: Z axis setter gauge - by PixMan - 04-20-2016, 06:39 AM
RE: Z axis setter gauge - by JScott - 04-20-2016, 08:07 AM
RE: Z axis setter gauge - by f350ca - 04-20-2016, 01:05 PM
|
