04-18-2016, 08:31 AM
You'll be fine. The shanks should be about 52-55Rc hardness (520-580HBn) so most good carbide will handle it. No worries. You shouldn't have to go to ceramic, which may have have issues with interrupted cuts.
|
LIL' HOGGERS
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
LIL' HOGGERS - by aRM - 04-12-2016, 08:56 AM
RE: LIL' HOGGERS - by johnnyc14 - 04-12-2016, 11:19 AM
RE: LIL' HOGGERS - by aRM - 04-12-2016, 11:44 AM
RE: LIL' HOGGERS - by schor - 04-12-2016, 03:15 PM
RE: LIL' HOGGERS - by the penguin - 04-12-2016, 07:04 PM
RE: LIL' HOGGERS - by PixMan - 04-14-2016, 01:22 PM
RE: LIL' HOGGERS - by aRM - 04-14-2016, 02:09 PM
RE: LIL' HOGGERS - by PixMan - 04-15-2016, 05:39 AM
RE: LIL' HOGGERS - by aRM - 04-15-2016, 07:55 AM
RE: LIL' HOGGERS - by Mayhem - 04-15-2016, 07:06 PM
RE: LIL' HOGGERS - by aRM - 04-16-2016, 12:25 AM
RE: LIL' HOGGERS - by PixMan - 04-15-2016, 08:05 PM
RE: LIL' HOGGERS - by aRM - 04-16-2016, 08:30 AM
RE: LIL' HOGGERS - by aRM - 04-16-2016, 08:54 AM
RE: LIL' HOGGERS - by PixMan - 04-17-2016, 07:28 AM
RE: LIL' HOGGERS - by aRM - 04-17-2016, 08:34 AM
RE: LIL' HOGGERS - by PixMan - 04-17-2016, 10:30 AM
RE: LIL' HOGGERS - by aRM - 04-17-2016, 11:55 AM
RE: LIL' HOGGERS - by PixMan - 04-18-2016, 08:31 AM
RE: LIL' HOGGERS - by aRM - 04-18-2016, 10:36 AM
RE: LIL' HOGGERS - by aRM - 04-18-2016, 11:48 AM
RE: LIL' HOGGERS - by aRM - 04-18-2016, 02:22 PM
RE: LIL' HOGGERS - by PixMan - 04-18-2016, 02:32 PM
RE: LIL' HOGGERS - by aRM - 04-19-2016, 01:19 AM
|
Users browsing this thread: 10 Guest(s)