04-15-2016, 07:06 PM
Hi aRM - are you going to use this mill up to a 90° shoulder or only ever face milling? The reason Ken asked is because a lot of face mills use inserts that will not enable you to mill up to a 90° shoulder.
If you take a look at the picture of the three mills in your original post, only the last one (triangular insert) would allow this.
You can face mill with a shoulder mill but you cannot always shoulder mill with a face mill.
If you take a look at the picture of the three mills in your original post, only the last one (triangular insert) would allow this.
You can face mill with a shoulder mill but you cannot always shoulder mill with a face mill.
Hunting American dentists since 2015.