MetalworkingFun Forum › Machining › Gunsmithing v
Making A Part For An Old Rifle

Thread Modes
Making A Part For An Old Rifle
rleete Offline
Senior
*****
Posts: 771
Threads: 48
Joined: Mar 2012
Location: Rochester, NY
#5
04-15-2016, 11:49 AM
I use O1 for pen bushings because they maintain concentricity and size after heat treating. Heat treating is done with used motor oil (non-synthetic) and a propane torch. Never had a bad part yet.
Full of ideas, but slow to produce parts
Reply
Thanks given by: EdK


Messages In This Thread
Making A Part For An Old Rifle - by EdK - 04-14-2016, 05:18 PM
RE: Making A Part For An Old Rifle - by TomG - 04-14-2016, 07:37 PM
RE: Making A Part For An Old Rifle - by EdK - 04-14-2016, 07:45 PM
RE: Making A Part For An Old Rifle - by TomG - 04-14-2016, 09:10 PM
RE: Making A Part For An Old Rifle - by rleete - 04-15-2016, 11:49 AM
RE: Making A Part For An Old Rifle - by Highpower - 04-15-2016, 12:41 PM
RE: Making A Part For An Old Rifle - by EdK - 04-15-2016, 04:36 PM
RE: Making A Part For An Old Rifle - by Highpower - 04-15-2016, 08:54 PM
RE: Making A Part For An Old Rifle - by EdK - 04-15-2016, 04:34 PM
RE: Making A Part For An Old Rifle - by Mayhem - 04-15-2016, 06:59 PM
RE: Making A Part For An Old Rifle - by EdK - 04-15-2016, 07:48 PM
RE: Making A Part For An Old Rifle - by EdK - 04-15-2016, 09:12 PM
RE: Making A Part For An Old Rifle - by Highpower - 04-16-2016, 07:56 AM
RE: Making A Part For An Old Rifle - by Vinny - 04-15-2016, 11:37 PM
RE: Making A Part For An Old Rifle - by EdK - 04-16-2016, 07:46 AM
RE: Making A Part For An Old Rifle - by EdK - 04-16-2016, 07:45 AM
RE: Making A Part For An Old Rifle - by EdK - 04-16-2016, 08:22 AM
RE: Making A Part For An Old Rifle - by EdK - 04-21-2016, 06:58 PM



Users browsing this thread: 3 Guest(s)