MetalworkingFun Forum › Machining › General Metalworking Discussion v
Help cutting an O ring grove

Thread Modes
Help cutting an O ring grove
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#6
04-11-2016, 01:14 PM
A 3/4 O ring seams large unless the sleeve fits really loose. The O ring should not be larger than the ID its fitting, you size the ID of your groove to stretch the O ring out and give the proper crush inside the bore.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Help cutting an O ring grove - by mike-sid - 04-10-2016, 08:46 PM
RE: Help cutting an O ring grove - by Mayhem - 04-11-2016, 06:02 AM
RE: Help cutting an O ring grove - by JScott - 04-11-2016, 01:04 PM
RE: Help cutting an O ring grove - by f350ca - 04-11-2016, 01:14 PM
RE: Help cutting an O ring grove - by TomG - 04-11-2016, 04:51 PM
RE: Help cutting an O ring grove - by mike-sid - 04-11-2016, 07:34 PM
RE: Help cutting an O ring grove - by mike-sid - 04-11-2016, 07:56 PM
RE: Help cutting an O ring grove - by TomG - 04-12-2016, 01:37 PM
RE: Help cutting an O ring grove - by mike-sid - 04-12-2016, 08:44 PM
RE: Help cutting an O ring grove - by PixMan - 04-20-2016, 08:55 AM
RE: Help cutting an O ring grove - by mike-sid - 04-24-2016, 08:47 PM
RE: Help cutting an O ring grove - by PixMan - 04-25-2016, 09:16 PM
RE: Help cutting an O ring grove - by mike-sid - 04-26-2016, 12:15 PM



Users browsing this thread: 1 Guest(s)