06-17-2012, 03:24 PM
(06-16-2012, 09:23 AM)Rickabilly Wrote: An excellent description of what needs to be done ...
Thank you very much for the detailed explanation. The only other thing you could have done was come here and do it.
If I understand you description and the statements about which side the miters were on the resulting frame would be two inches high. The 45 degree miter will be on the 2 inch sides ... i.e. what I think is the 2.8 inches of weld scenario, and the resulting frame will be six inches high. I hope that makes sense.
If that is the case would there be a change in the order or the location of the welds?
Again thanks for the excellent description,
Arvid