MetalworkingFun Forum › Machining › General Metalworking Discussion v
LibreCAD squiggle trimming?

Thread Modes
LibreCAD squiggle trimming?
kennyg Offline
Freshman
**
Posts: 6
Threads: 2
Joined: Mar 2016
Location: Montana
#14
04-09-2016, 06:18 PM
I used librecad for a while and found it kind of klugy it is actually the bastard child of Qcad which you can get for linux but it costs 30$ IIRC I found it worth it.
Reply
Thanks given by:


Messages In This Thread
LibreCAD squiggle trimming? - by Sunset Machine - 02-26-2016, 01:12 PM
RE: LibreCAD squiggle trimming? - by EdK - 02-26-2016, 02:34 PM
RE: LibreCAD squiggle trimming? - by EdK - 02-27-2016, 09:37 AM
RE: LibreCAD squiggle trimming? - by EdK - 02-27-2016, 06:58 PM
RE: LibreCAD squiggle trimming? - by EdK - 02-28-2016, 12:58 PM
RE: LibreCAD squiggle trimming? - by rleete - 03-02-2016, 12:13 PM
RE: LibreCAD squiggle trimming? - by kennyg - 04-09-2016, 06:18 PM
RE: LibreCAD squiggle trimming? - by Vinny - 04-09-2016, 06:28 PM
RE: LibreCAD squiggle trimming? - by Vinny - 04-10-2016, 01:39 PM
RE: LibreCAD squiggle trimming? - by kennyg - 04-10-2016, 02:02 PM
RE: LibreCAD squiggle trimming? - by kennyg - 04-10-2016, 04:34 PM
RE: LibreCAD squiggle trimming? - by f350ca - 04-10-2016, 06:29 PM
RE: LibreCAD squiggle trimming? - by Vinny - 04-10-2016, 08:01 PM
RE: LibreCAD squiggle trimming? - by EdK - 04-11-2016, 07:09 AM
RE: LibreCAD squiggle trimming? - by Vinny - 04-11-2016, 04:09 PM



Users browsing this thread: 3 Guest(s)