06-17-2012, 12:44 PM
Henry, I'm sorry, I didn't mean to goad you into posting the schematic.
As you may have noticed I posted a pic of my perm. mag. DC gearmotor for my mill drill. I actually have no need for the schematic.
I was just funin' ya about being cautious (not one of my talents, to my dismay I might add).
I am a little curious as to whether or not you are powering your 180vdc gearmotor from a 120 vac line.
Or have I misinterpreted.
As you may have noticed I posted a pic of my perm. mag. DC gearmotor for my mill drill. I actually have no need for the schematic.
I was just funin' ya about being cautious (not one of my talents, to my dismay I might add).
I am a little curious as to whether or not you are powering your 180vdc gearmotor from a 120 vac line.
Or have I misinterpreted.
(06-16-2012, 12:03 PM)henryarnold Wrote: The schematic I was going to publish used 120 VAC as an input
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.