Setting Up My PM935 Mill

[EdK]

Finally some progress with the mother ship. Got it safely off of the pallet and onto the floor. I thought the front end was going to dip much more than it did. It sits solidly on the floor with no rocking at all and if does the same when I get it down into the basement I don't think I'll need any levelling feet. It looks like it might be at the ideal height for my short stature.  

I was surprised that the mounting holes were tapped. I thought they would be just through holes. They must be metric since they're larger than 5/8 and a 3/4 bolt doesn't fit the threads. It must be 19mm.

Tomorrow I'll attempt to get it on its back on the sled.  

Ed