03-18-2016, 11:08 PM
Chapter Two: A Fresh Start ... or is it? 
Got the new switch in hand today to see what I could see....
First I checked the resistor that feeds the original neon lamp bulb at 32.97K? (Spec is 33K? 5%)
Then I attached a couple of jumper wires to the molex connector for the new ring light and applied them to the old neon lamp leads, and she lit up just fine.
Now I just have to hope I guessed at ordering the correct mating connector and pins to connect the switch to.
There are thousands of them.
Got the new switch in hand today to see what I could see....
First I checked the resistor that feeds the original neon lamp bulb at 32.97K? (Spec is 33K? 5%)
Then I attached a couple of jumper wires to the molex connector for the new ring light and applied them to the old neon lamp leads, and she lit up just fine.
Now I just have to hope I guessed at ordering the correct mating connector and pins to connect the switch to.
There are thousands of them.
Willie