|
Making a duck call jig
|
03-18-2016, 11:31 AM
It doesn't have to be anything fancy. This is one I made to square up corners that have a radius left over from an end mill. The bolt sticking thru the side is for keeping the backlash out of the spindle splines. You don't want your cutter rotating back and forth between strokes of the quill.
![[Image: Shaper_Tool.jpg]](http://img.photobucket.com/albums/v82/Highpwr/Machining%20a%20receiver/Shaper_Tool.jpg)
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Making a duck call jig - by JScott - 02-29-2016, 04:04 PM
RE: Making a duck call jig - by DaveH - 02-29-2016, 06:31 PM
RE: Making a duck call jig - by JScott - 03-07-2016, 04:32 PM
RE: Making a duck call jig - by TomG - 03-07-2016, 07:46 PM
RE: Making a duck call jig - by JScott - 03-14-2016, 11:42 AM
RE: Making a duck call jig - by JScott - 03-17-2016, 12:34 PM
RE: Making a duck call jig - by Highpower - 03-17-2016, 12:52 PM
RE: Making a duck call jig - by JScott - 03-17-2016, 01:39 PM
RE: Making a duck call jig - by TomG - 03-17-2016, 07:13 PM
RE: Making a duck call jig - by JScott - 03-18-2016, 08:50 AM
RE: Making a duck call jig - by TomG - 03-18-2016, 09:16 AM
RE: Making a duck call jig - by JScott - 03-18-2016, 10:14 AM
RE: Making a duck call jig - by Highpower - 03-18-2016, 11:31 AM
RE: Making a duck call jig - by JScott - 03-18-2016, 11:44 AM
RE: Making a duck call jig - by Sunset Machine - 03-18-2016, 12:14 PM
RE: Making a duck call jig - by JScott - 03-18-2016, 12:50 PM
|
