03-13-2016, 10:06 AM
Last month I bought a new Millermatic 252 welder from the LWS. This was to replace my Millermatic 175. THe MM175 is a good welder, but will not run my Miller 30A spool gun. I have a MM350P, and its set up for .045" wire, in pulse mode using 90/10 shielding gas, I set the new MM252 up to run .030" wire, with 75/25 shielding gas and pure argon for the spool gun.
At the same time I bought a 20' Tweco #1 gun with a flexible gooseneck for the welder, replacing the 15' M25 gun, that was supplied with the welder.
1 - the welder
2 - the gooseneck straight
3- goose neck at 85 degrees
4 - welder in the back of the shop
5 - whats still usable in the front of the shop
At the same time I bought a 20' Tweco #1 gun with a flexible gooseneck for the welder, replacing the 15' M25 gun, that was supplied with the welder.
1 - the welder
2 - the gooseneck straight
3- goose neck at 85 degrees
4 - welder in the back of the shop
5 - whats still usable in the front of the shop
jack