03-12-2016, 10:02 AM
(This post was last modified: 03-12-2016, 10:03 AM by the penguin.)
(03-12-2016, 09:48 AM)EdK Wrote:(03-12-2016, 09:45 AM)the penguin Wrote: Ed,
too bad its a new mill, if it was mine or used, I go buy a 1" holesaw and be done with it...............
I actually had thought of that but I'd wuss out as the plot drill got close to the shiny paint job.
Ed
very understandable, I felt the same way when I put the powerfeed on the mills, drilling the mill for the travel limit tracks, that first hole was rough, the rest came very easily. Now everytime I reach for a drill, the mills tremble a little in fear.
jack