MetalworkingFun Forum › Machining › Projects v
Electronics Question (again...)

Thread Modes
Electronics Question (again...)
EdK Offline
Whipping Boy
*******
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#12
03-12-2016, 08:35 AM
(03-12-2016, 08:24 AM)pepi Wrote: that neon bulb is a game changer.

Not really, you can get LED pilot/panel lights that will run on 110/220VAC.

Ed
Reply
Thanks given by:


Messages In This Thread
Electronics Question (again...) - by Highpower - 03-11-2016, 01:40 PM
RE: Electronics Question (again...) - by EdK - 03-11-2016, 05:01 PM
RE: Electronics Question (again...) - by f350ca - 03-11-2016, 06:16 PM
RE: Electronics Question (again...) - by Vinny - 03-11-2016, 07:28 PM
RE: Electronics Question (again...) - by pepi - 03-12-2016, 08:24 AM
RE: Electronics Question (again...) - by EdK - 03-11-2016, 07:43 PM
RE: Electronics Question (again...) - by Mayhem - 03-11-2016, 07:51 PM
RE: Electronics Question (again...) - by Vinny - 03-11-2016, 07:51 PM
RE: Electronics Question (again...) - by EdK - 03-12-2016, 08:35 AM
RE: Electronics Question (again...) - by pepi - 03-12-2016, 10:53 PM
RE: Electronics Question (again...) - by Mayhem - 03-12-2016, 09:27 AM
RE: Electronics Question (again...) - by EdK - 03-12-2016, 03:04 PM
RE: Electronics Question (again...) - by Mayhem - 03-12-2016, 07:27 PM
RE: Electronics Question (again...) - by pepi - 03-19-2016, 07:23 AM
RE: Electronics Question (again...) - by EdK - 03-19-2016, 12:14 PM
RE: Electronics Question (again...) - by EdK - 03-19-2016, 03:23 PM



Users browsing this thread: 3 Guest(s)