MetalworkingFun Forum › Machining › Projects v
Electronics Question (again...)

Thread Modes
Electronics Question (again...)
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#8
03-11-2016, 07:51 PM
(03-11-2016, 07:48 PM)Highpower Wrote: ...The way they show it in the drawings though, the light would come on as soon as the power cord was plugged in - and I know that isn't right. Slaphead...

No - as Vinny pointed out, the input into the circuit board is after the power switch.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Electronics Question (again...) - by Highpower - 03-11-2016, 01:40 PM
RE: Electronics Question (again...) - by EdK - 03-11-2016, 05:01 PM
RE: Electronics Question (again...) - by f350ca - 03-11-2016, 06:16 PM
RE: Electronics Question (again...) - by Vinny - 03-11-2016, 07:28 PM
RE: Electronics Question (again...) - by pepi - 03-12-2016, 08:24 AM
RE: Electronics Question (again...) - by EdK - 03-11-2016, 07:43 PM
RE: Electronics Question (again...) - by Mayhem - 03-11-2016, 07:51 PM
RE: Electronics Question (again...) - by Vinny - 03-11-2016, 07:51 PM
RE: Electronics Question (again...) - by EdK - 03-12-2016, 08:35 AM
RE: Electronics Question (again...) - by pepi - 03-12-2016, 10:53 PM
RE: Electronics Question (again...) - by Mayhem - 03-12-2016, 09:27 AM
RE: Electronics Question (again...) - by EdK - 03-12-2016, 03:04 PM
RE: Electronics Question (again...) - by Mayhem - 03-12-2016, 07:27 PM
RE: Electronics Question (again...) - by pepi - 03-19-2016, 07:23 AM
RE: Electronics Question (again...) - by EdK - 03-19-2016, 12:14 PM
RE: Electronics Question (again...) - by EdK - 03-19-2016, 03:23 PM



Users browsing this thread: 5 Guest(s)