MetalworkingFun Forum › Machining › Projects v
Electronics Question (again...)

Thread Modes
Electronics Question (again...)
EdK Offline
Whipping Boy
*******
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#6
03-11-2016, 07:43 PM
(03-11-2016, 07:28 PM)Vinny Wrote: Almost forgot, the reason the lamp looks to be wired right across the line is because the schematic is of the circuit board, the power switch is not mounted to it.

Good catch Vinny. Thumbsup

J-1-4 is where the switch would be wired in.

Ed
Reply
Thanks given by:


Messages In This Thread
Electronics Question (again...) - by Highpower - 03-11-2016, 01:40 PM
RE: Electronics Question (again...) - by EdK - 03-11-2016, 05:01 PM
RE: Electronics Question (again...) - by f350ca - 03-11-2016, 06:16 PM
RE: Electronics Question (again...) - by Vinny - 03-11-2016, 07:28 PM
RE: Electronics Question (again...) - by pepi - 03-12-2016, 08:24 AM
RE: Electronics Question (again...) - by EdK - 03-11-2016, 07:43 PM
RE: Electronics Question (again...) - by Mayhem - 03-11-2016, 07:51 PM
RE: Electronics Question (again...) - by Vinny - 03-11-2016, 07:51 PM
RE: Electronics Question (again...) - by EdK - 03-12-2016, 08:35 AM
RE: Electronics Question (again...) - by pepi - 03-12-2016, 10:53 PM
RE: Electronics Question (again...) - by Mayhem - 03-12-2016, 09:27 AM
RE: Electronics Question (again...) - by EdK - 03-12-2016, 03:04 PM
RE: Electronics Question (again...) - by Mayhem - 03-12-2016, 07:27 PM
RE: Electronics Question (again...) - by pepi - 03-19-2016, 07:23 AM
RE: Electronics Question (again...) - by EdK - 03-19-2016, 12:14 PM
RE: Electronics Question (again...) - by EdK - 03-19-2016, 03:23 PM



Users browsing this thread: 3 Guest(s)