03-09-2016, 09:59 PM
(03-05-2016, 02:23 AM)Vinny Wrote: Did you get the bevel gear that goes with that power feed? I'd like as much info as possible on it. (DP, TP, PA)
Vince, I've got my table power feed apart right now so I had a look at the bevel gear on mine. 24 DP and 20° PA.
This is on an "ALIGN" model AL-300S. Don't know if that does you any good or not...
My table feed has gotten pretty noisy so I wanted to have a look-see. Don't know where the grease went but both gears were pretty much bone dry. The bottom gear cover was full of oil, which I assume is melted grease from the drive gear. No info in my manual at all covering any kind of maintenance or what types of lube to use.
I suppose I should pick up some spare plastic drive gears if I can find any.
Willie