Setting Up My PM935 Mill

[Mayhem]

(03-07-2016, 11:01 AM)EdK Wrote:

(03-07-2016, 10:31 AM)Mayhem Wrote: Ed - you have four bolt holes at the top of the casting that will give you a good, balanced point.

I wish! That would make it easy but no bolt holes anywhere except the four base mounting holes. That's why I was considering using the turret spider and some bar stock. That would put the lifting point at the very top.

Ed

Sorry - I thought from an earlier post that you had put the spider and turret back on. I wouldn't lift from just the spider but I would with the turret in place