03-06-2016, 05:52 PM
Thanks for the responses, guys. I tried to attach 2 pics but I get an error message that the pic file is too large.
EdK, thanks for the post. I got the worm drive out and got that cleaned up. The poster you quoted mentions a nut on the bottom of the table. To me that is a hex head of some size; I don't have that. I do have a flat plate which rotates with the table. It is only about 1/4" thick and has 2 set screws drilled in from the side about 30 degrees apart (a funny arrangement). I have those backed out and tried using a punch to move the table but no luck. It has two blind holes 90 degrees apart so maybe it is the nut and it needs a pin wrench of some type to remove it.
If anyone can tell me how to reduce the size of a picture file, I'll send the pics.
John
EdK, thanks for the post. I got the worm drive out and got that cleaned up. The poster you quoted mentions a nut on the bottom of the table. To me that is a hex head of some size; I don't have that. I do have a flat plate which rotates with the table. It is only about 1/4" thick and has 2 set screws drilled in from the side about 30 degrees apart (a funny arrangement). I have those backed out and tried using a punch to move the table but no luck. It has two blind holes 90 degrees apart so maybe it is the nut and it needs a pin wrench of some type to remove it.
If anyone can tell me how to reduce the size of a picture file, I'll send the pics.
John