MetalworkingFun Forum › Machining › General Metalworking Discussion v
Floor mats

Thread Modes
Floor mats
big job Offline
Sophmore
***
Posts: 51
Threads: 0
Joined: Jun 2012
Location: S.E. Mass
#9
06-15-2012, 04:40 AM
Mine is about 4x6' one inch thick the kind with one inch holes. The holes catch swarf,
nice on my feet and as for dropping say a nut (that always dissapears) it will catch
that too. Somebody gave it to me long ago. Just pick it up and sweep. Its a catch all.
big job, proud to be a member of MetalworkingFun since Jun 2012.
Reply
Thanks given by:


Messages In This Thread
Floor mats - by DanH - 06-14-2012, 12:39 PM
RE: Floor mats - by rleete - 06-14-2012, 01:20 PM
RE: Floor mats - by stevec - 06-14-2012, 03:54 PM
RE: Floor mats - by EdK - 06-14-2012, 05:38 PM
RE: Floor mats - by henryarnold - 06-14-2012, 10:49 PM
RE: Floor mats - by EdK - 06-15-2012, 04:55 PM
RE: Floor mats - by stevec - 06-14-2012, 06:26 PM
RE: Floor mats - by EdK - 06-14-2012, 06:45 PM
RE: Floor mats - by tlfamm - 06-14-2012, 06:33 PM
RE: Floor mats - by big job - 06-15-2012, 04:40 AM
RE: Floor mats - by mikecwik - 06-16-2012, 07:03 PM
RE: Floor mats - by lemelman - 07-18-2012, 02:02 AM
RE: Floor mats - by doubleboost - 07-18-2012, 04:18 PM
RE: Floor mats - by krv3000 - 07-18-2012, 06:38 PM
RE: Floor mats - by Mayhem - 07-18-2012, 08:56 PM
RE: Floor mats - by TomG - 07-19-2012, 07:53 PM
RE: Floor mats - by Mayhem - 07-19-2012, 09:14 PM
RE: Floor mats - by ETC57 - 07-19-2012, 10:05 PM



Users browsing this thread: 1 Guest(s)