03-02-2016, 05:25 PM
Evening Gents!
This is a worm shaft from a Yuasa 550 - 050 rotary table. As you can see its not as straight as it should be!
Do you think it will straighten out with some serious heat and muscle, or should I just try and source a replacement part? According to the manual it is hardened and ground. Also I cant disassemble it any further because of the bend in the shaft.
Thoughts please.
Thanks in advance.
John
[attachment=12890]
[attachment=12891]
This is a worm shaft from a Yuasa 550 - 050 rotary table. As you can see its not as straight as it should be!
Do you think it will straighten out with some serious heat and muscle, or should I just try and source a replacement part? According to the manual it is hardened and ground. Also I cant disassemble it any further because of the bend in the shaft.
Thoughts please.
Thanks in advance.
John
[attachment=12890]
[attachment=12891]