02-28-2016, 03:18 PM
Linux, yes. Gave up on MS twenty years ago. As for LibreCAD... My ignorance of the others probably helps keep the frustration level down.
LibreCAD is several steps above paperCAD though. I made some gears for this box the other day, one tooth short and a half-DP larger from the original. The darn things dropped right into place first try. Without the CAD it would have been far more difficult. Welcome to the 21st century Jimbo, where'ya been?
The carbide challenge lies ahead.... I'm about 40 years behind the times on that too.
LibreCAD is several steps above paperCAD though. I made some gears for this box the other day, one tooth short and a half-DP larger from the original. The darn things dropped right into place first try. Without the CAD it would have been far more difficult. Welcome to the 21st century Jimbo, where'ya been?
The carbide challenge lies ahead.... I'm about 40 years behind the times on that too.