Fitted DRO to Lathe, showed up movement

Hello There, Guest! Register

Thread Modes

Fitted DRO to Lathe, showed up movement

EdK

Offline

Whipping Boy

Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota

#8

02-27-2016, 06:52 PM

(02-27-2016, 12:21 PM)Sunset Machine Wrote: , but not for general turning.

Why?

17428

Ed

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Fitted DRO to Lathe, showed up movement - by rotorhead - 02-27-2016, 08:31 AM

RE: Fitted DRO to Lathe, showed up movement - by EdK - 02-27-2016, 09:20 AM

RE: Fitted DRO to Lathe, showed up movement - by Sunset Machine - 02-27-2016, 10:04 AM

RE: Fitted DRO to Lathe, showed up movement - by EdK - 02-27-2016, 10:49 AM

RE: Fitted DRO to Lathe, showed up movement - by Sunset Machine - 02-27-2016, 12:21 PM

RE: Fitted DRO to Lathe, showed up movement - by mfletch - 02-27-2016, 11:05 AM

RE: Fitted DRO to Lathe, showed up movement - by rotorhead - 02-27-2016, 05:15 PM

RE: Fitted DRO to Lathe, showed up movement - by EdK - 02-27-2016, 06:52 PM

RE: Fitted DRO to Lathe, showed up movement - by Sunset Machine - 02-28-2016, 10:01 AM

RE: Fitted DRO to Lathe, showed up movement - by rotorhead - 02-28-2016, 03:57 AM

RE: Fitted DRO to Lathe, showed up movement - by awemawson - 02-28-2016, 08:34 AM

RE: Fitted DRO to Lathe, showed up movement - by rotorhead - 02-28-2016, 03:38 PM

RE: Fitted DRO to Lathe, showed up movement - by TomG - 02-28-2016, 04:07 PM

RE: Fitted DRO to Lathe, showed up movement - by rotorhead - 02-28-2016, 06:39 PM

RE: Fitted DRO to Lathe, showed up movement - by TomG - 02-28-2016, 08:58 PM

RE: Fitted DRO to Lathe, showed up movement - by rotorhead - 03-01-2016, 11:54 AM

Users browsing this thread: 2 Guest(s)