Need advice - belt grinder or bench grinder?

[ScrapMetal]

Yeah, my "shop" is actually in a single stall garage at my office building.  The garage is on the other side of the parking lot and it was only wired for single phase.  Since the wiring for the garage was drawing from the equipment room in the office basement I was able to pull some more wire through the conduit to bring it up to 3-phase.   Currently I have designs on the stall next to my "shop" so I can double my square footage and buy more equipment.    It's going to take a bit of finagling to get that though.

Here are a couple pics moving my Wells Index 860 into the "shop"...





Yes, that is a furnace in the garage.

-Ron