06-14-2012, 10:02 AM
It Does look Good Darren,
My Colchester Mascot had all of it's wiring done in single core hard wires all accurately bent and self supporting, when I redid that I was at my old R&D workshop and we had a few guys that did nothing except wiring up control circuits, so I dragged them over to see what the OLD days looked like, and they just shrugged it off saying they couldn't be bothered and what was the point? Just goes to show the state of modern trade pride, I rewired that machine just thirty miles from where it was originally built, after it had been in Australia for 45 years, but those guys were a million miles away from the tradies that did the original work.
Best Regards
Rick
My Colchester Mascot had all of it's wiring done in single core hard wires all accurately bent and self supporting, when I redid that I was at my old R&D workshop and we had a few guys that did nothing except wiring up control circuits, so I dragged them over to see what the OLD days looked like, and they just shrugged it off saying they couldn't be bothered and what was the point? Just goes to show the state of modern trade pride, I rewired that machine just thirty miles from where it was originally built, after it had been in Australia for 45 years, but those guys were a million miles away from the tradies that did the original work.
Best Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.