06-13-2012, 07:59 PM
I weld angle like that everyday 3/8"-1/2" thick with a mig or stick. Tig is another story as i am not well versed on it even though i have 2 machines i am not an expert at it.
I would tack it and run the corner downhill then run the inside bottom flat. Just my thoughts...Bob
I would tack it and run the corner downhill then run the inside bottom flat. Just my thoughts...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...