02-05-2016, 04:40 PM
I'm going though my tool libraries in Fusion 360 CAM (you really have to create one for each material type) and unlike some CAD/CAM programs I've used each tool is tied to a specific feed and speed rather than them being modified by you detailing the material you are cutting. (They can be over-ridden when you define the CAM operation)
So I thought that it would be nice to put some science behind what I enter for my Feeds & Speed rather than 'guess and tweak on breakage'![[Image: confused0068.gif]](http://madmodder.net/Smileys/default/confused0068.gif)
Hence looking on line for Feeds & Speeds calculators. G wizard is the 'famous' one but it isn't free. FSWizard is free but perhaps a bit clunky. Are there any others I should be looking at. It needs to operate Metric as well as Imperial, and preferably be on my computer rather than on line.
So what are you using, or is it a wet finger in the air![[Image: kranke_200-1.gif]](http://madmodder.net/Smileys/default/kranke_200-1.gif)
So I thought that it would be nice to put some science behind what I enter for my Feeds & Speed rather than 'guess and tweak on breakage'
Hence looking on line for Feeds & Speeds calculators. G wizard is the 'famous' one but it isn't free. FSWizard is free but perhaps a bit clunky. Are there any others I should be looking at. It needs to operate Metric as well as Imperial, and preferably be on my computer rather than on line.
So what are you using, or is it a wet finger in the air
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.