|
Help Unknown Dividing Head
|
02-04-2016, 06:43 AM
The fact that is has the drive shaft would be an indication that it was made by a machine builder to mate with output gears on the table drive. This enables you to make things such as spiral cut gears. Of course it may be built by another company in cooperation with a machine tool builder, though when they have the drive it more commonly was sold with the machine to which it mated up.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Unknown Dividing Head - by rotorhead - 02-02-2016, 07:27 PM
RE: Unknown Dividing Head - by Pete O - 02-03-2016, 06:34 AM
RE: Unknown Dividing Head - by rotorhead - 02-03-2016, 11:19 AM
RE: Unknown Dividing Head - by EdK - 02-03-2016, 01:06 PM
RE: Unknown Dividing Head - by dallen - 02-03-2016, 02:22 PM
RE: Unknown Dividing Head - by rotorhead - 02-03-2016, 05:55 PM
RE: Unknown Dividing Head - by PixMan - 02-04-2016, 06:43 AM
RE: Unknown Dividing Head - by Pete O - 02-04-2016, 07:08 AM
RE: Unknown Dividing Head - by Mayhem - 02-04-2016, 07:18 AM
RE: Unknown Dividing Head - by rotorhead - 02-04-2016, 08:29 AM
RE: Unknown Dividing Head - by Sunset Machine - 02-04-2016, 10:14 AM
RE: Unknown Dividing Head - by rotorhead - 02-04-2016, 01:00 PM
|
