MetalworkingFun Forum › Machining › Welding & Casting v
How it used to be done

Thread Modes
How it used to be done
Rickabilly Offline
Junior
****
Posts: 537
Threads: 15
Joined: Jun 2012
Location: Cambridge, England
#15
06-13-2012, 03:47 PM
Hello Rob,
What is it you do in the Forge shop?

I used to do steam hammer repairs from time to time as an Apprentice, Back at the Steelworks where I trained.

Best regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
Reply
Thanks given by:


Messages In This Thread
How it used to be done - by doubleboost - 04-26-2012, 04:26 PM
RE: How it used to be done - by krv3000 - 04-26-2012, 04:35 PM
RE: How it used to be done - by DaveH - 04-26-2012, 04:39 PM
RE: How it used to be done - by RobWilson - 04-27-2012, 09:42 AM
RE: How it used to be done - by DaveH - 04-27-2012, 09:55 AM
RE: How it used to be done - by RobWilson - 04-27-2012, 12:03 PM
RE: How it used to be done - by EdK - 04-27-2012, 12:09 PM
RE: How it used to be done - by RobWilson - 04-27-2012, 12:17 PM
RE: How it used to be done - by stevec - 04-27-2012, 02:56 PM
RE: How it used to be done - by DaveH - 04-27-2012, 03:07 PM
RE: How it used to be done - by RobWilson - 04-27-2012, 03:37 PM
RE: How it used to be done - by DaveH - 04-27-2012, 03:42 PM
RE: How it used to be done - by EdK - 04-27-2012, 04:00 PM
RE: How it used to be done - by RobWilson - 04-27-2012, 04:11 PM
RE: How it used to be done - by Rickabilly - 06-13-2012, 03:47 PM
RE: How it used to be done - by RobWilson - 06-13-2012, 04:01 PM
RE: How it used to be done - by Rickabilly - 06-14-2012, 05:03 AM



Users browsing this thread: 4 Guest(s)