06-13-2012, 03:40 PM
Yeah, pretty much,
But I'd lay the joint flat on the bench, it's easier to let gravity drop the weld metal where you want it, rather than trying to keep it up on the side like that, so rotate your image 90 degrees anti clockwise and then lift your torch up to about 60degrees above horizontal and off you go.
Best Regards
Rick
But I'd lay the joint flat on the bench, it's easier to let gravity drop the weld metal where you want it, rather than trying to keep it up on the side like that, so rotate your image 90 degrees anti clockwise and then lift your torch up to about 60degrees above horizontal and off you go.
Best Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.