01-09-2016, 03:19 AM
Hi Mike,
I had the same problem and it was very frustrating. Nothing in the manual says how to solve that.
I change so many values I stop keeping tracks of them. I remember I setted a value to 0 to use the automatic option of the VFD. I think it was d2-01 but you wrote you tried it. However, after the change I never had that Err.2 again at it runs without any issues for the last 4 months.
Other settings different to yours :
d0-02 = 2.0
d0-04 = 3450
I used autotuning for d0-05 and others
Now I am trying to find the way to make LinuxCNC control the spindle off/on and speed but I am no electrical tech and most of the stuff in the manual could be chinese it would not make much difference to me.
Regards
Fern
I had the same problem and it was very frustrating. Nothing in the manual says how to solve that.
I change so many values I stop keeping tracks of them. I remember I setted a value to 0 to use the automatic option of the VFD. I think it was d2-01 but you wrote you tried it. However, after the change I never had that Err.2 again at it runs without any issues for the last 4 months.
Other settings different to yours :
d0-02 = 2.0
d0-04 = 3450
I used autotuning for d0-05 and others
Now I am trying to find the way to make LinuxCNC control the spindle off/on and speed but I am no electrical tech and most of the stuff in the manual could be chinese it would not make much difference to me.
Regards
Fern