MetalworkingFun Forum › Machining › General Metalworking Discussion v
Turning Down a Motor Shaft

Thread Modes
Turning Down a Motor Shaft
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#21
06-11-2012, 03:50 PM
(06-11-2012, 03:09 PM)stevec Wrote: Ed, have we determined what source of 3 ph power you'll be using?

Steve,

It'll be a Teco JNEV-203-H1 VFD.

Ed
Reply
Thanks given by:


Messages In This Thread
Turning Down a Motor Shaft - by EdK - 06-03-2012, 05:53 PM
RE: Turning Down a Motor Shaft - by November X-ray - 06-03-2012, 06:51 PM
RE: Turning Down a Motor Shaft - by stevec - 06-03-2012, 07:20 PM
RE: Turning Down a Motor Shaft - by f350ca - 06-03-2012, 08:44 PM
RE: Turning Down a Motor Shaft - by Mayhem - 06-03-2012, 09:41 PM
RE: Turning Down a Motor Shaft - by Tony Wells - 06-03-2012, 09:41 PM
RE: Turning Down a Motor Shaft - by EdK - 06-04-2012, 07:41 AM
RE: Turning Down a Motor Shaft - by jhovel - 06-07-2012, 06:27 AM
RE: Turning Down a Motor Shaft - by stevec - 06-07-2012, 06:31 PM
RE: Turning Down a Motor Shaft - by dallen - 06-07-2012, 10:00 PM
RE: Turning Down a Motor Shaft - by Tony Wells - 06-08-2012, 09:02 PM
RE: Turning Down a Motor Shaft - by EdK - 06-09-2012, 03:59 PM
RE: Turning Down a Motor Shaft - by Highpower - 06-10-2012, 08:06 AM
RE: Turning Down a Motor Shaft - by EdK - 06-11-2012, 03:47 PM
RE: Turning Down a Motor Shaft - by EdK - 06-09-2012, 04:00 PM
RE: Turning Down a Motor Shaft - by stevec - 06-09-2012, 07:11 PM
RE: Turning Down a Motor Shaft - by stevec - 06-11-2012, 03:09 PM
RE: Turning Down a Motor Shaft - by EdK - 06-11-2012, 03:50 PM
RE: Turning Down a Motor Shaft - by stevec - 06-12-2012, 06:39 AM
RE: Turning Down a Motor Shaft - by doubleboost - 06-12-2012, 03:45 PM



Users browsing this thread: 1 Guest(s)