Setting Up KOC100 VFD

Thread Modes

Setting Up KOC100 VFD

Hawkeye Offline

Junior

Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada

#26

01-01-2016, 09:27 PM

I'm assuming it wasn't even tested. All the terminal screws were snugged up. Doesn't seem like they ever had wires connected to them. Kind of a good news/bad news scenario. Not run with no motor, but probably not tested before shipping it half way around the world.

The manual seems to have an error, though. Page 36 mentions d2-00 as "Motor Rated Power" for the second motor, while Page 139 lists d2-00 as "V/F Curve Setting". Hard to work with details like that.

Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Setting Up KOC100 VFD - by Hawkeye - 12-28-2015, 11:16 PM

RE: Setting Up KOC100 VFD - by RobWilson - 12-29-2015, 03:15 AM

RE: Setting Up KOC100 VFD - by RobWilson - 12-29-2015, 01:19 PM

RE: Setting Up KOC100 VFD - by Highpower - 12-29-2015, 04:10 AM

RE: Setting Up KOC100 VFD - by EdK - 12-29-2015, 10:13 AM

RE: Setting Up KOC100 VFD - by Hawkeye - 12-29-2015, 12:09 PM

RE: Setting Up KOC100 VFD - by Highpower - 12-29-2015, 01:49 PM

RE: Setting Up KOC100 VFD - by wawoodman - 12-29-2015, 02:22 PM