MetalworkingFun Forum › Machining › General Metalworking Discussion v
Kurt Alternatives?

Thread Modes
Kurt Alternatives?
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#2
01-01-2016, 02:13 AM
I have a Taiwanese Vertex vice, which I am happy with. I looked at Glacern and Kurt but shipping from the US to Aus was way too much. I could get a Kurt here but for twice what you pay in the US. The Glacern look to be very nice.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Kurt Alternatives? - by Roadracer_Al - 12-31-2015, 11:50 PM
RE: Kurt Alternatives? - by Mayhem - 01-01-2016, 02:13 AM
RE: Kurt Alternatives? - by johnnyc14 - 01-01-2016, 07:45 AM
RE: Kurt Alternatives? - by EdK - 01-01-2016, 09:23 AM
RE: Kurt Alternatives? - by wawoodman - 01-01-2016, 10:48 AM
RE: Kurt Alternatives? - by Dr Stan - 01-01-2016, 11:05 AM
RE: Kurt Alternatives? - by Roadracer_Al - 01-02-2016, 12:00 AM
RE: Kurt Alternatives? - by PixMan - 01-08-2016, 03:53 PM
RE: Kurt Alternatives? - by zmotorsports - 01-08-2016, 04:50 PM
RE: Kurt Alternatives? - by Roadracer_Al - 02-26-2016, 04:53 PM
RE: Kurt Alternatives? - by Dr Stan - 03-01-2016, 12:35 PM
RE: Kurt Alternatives? - by Roadracer_Al - 03-01-2016, 09:48 PM



Users browsing this thread: 3 Guest(s)