MetalworkingFun Forum › Machining › General Metalworking Discussion v
Turning Down a Motor Shaft

Thread Modes
Turning Down a Motor Shaft
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#19
06-11-2012, 03:09 PM
Ed, have we determined what source of 3 ph power you'll be using?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Turning Down a Motor Shaft - by EdK - 06-03-2012, 05:53 PM
RE: Turning Down a Motor Shaft - by November X-ray - 06-03-2012, 06:51 PM
RE: Turning Down a Motor Shaft - by stevec - 06-03-2012, 07:20 PM
RE: Turning Down a Motor Shaft - by f350ca - 06-03-2012, 08:44 PM
RE: Turning Down a Motor Shaft - by Mayhem - 06-03-2012, 09:41 PM
RE: Turning Down a Motor Shaft - by Tony Wells - 06-03-2012, 09:41 PM
RE: Turning Down a Motor Shaft - by EdK - 06-04-2012, 07:41 AM
RE: Turning Down a Motor Shaft - by jhovel - 06-07-2012, 06:27 AM
RE: Turning Down a Motor Shaft - by stevec - 06-07-2012, 06:31 PM
RE: Turning Down a Motor Shaft - by dallen - 06-07-2012, 10:00 PM
RE: Turning Down a Motor Shaft - by Tony Wells - 06-08-2012, 09:02 PM
RE: Turning Down a Motor Shaft - by EdK - 06-09-2012, 03:59 PM
RE: Turning Down a Motor Shaft - by Highpower - 06-10-2012, 08:06 AM
RE: Turning Down a Motor Shaft - by EdK - 06-11-2012, 03:47 PM
RE: Turning Down a Motor Shaft - by EdK - 06-09-2012, 04:00 PM
RE: Turning Down a Motor Shaft - by stevec - 06-09-2012, 07:11 PM
RE: Turning Down a Motor Shaft - by stevec - 06-11-2012, 03:09 PM
RE: Turning Down a Motor Shaft - by EdK - 06-11-2012, 03:50 PM
RE: Turning Down a Motor Shaft - by stevec - 06-12-2012, 06:39 AM
RE: Turning Down a Motor Shaft - by doubleboost - 06-12-2012, 03:45 PM



Users browsing this thread: 2 Guest(s)