MetalworkingFun Forum › Machinery › Lathes v
Zyto Lathe Pics

Thread Modes
Zyto Lathe Pics
Sunset Machine Offline
Junior
****
Posts: 716
Threads: 32
Joined: Apr 2012
Location: Washington, USA
#10
12-30-2015, 09:31 AM
The chart is saying to stack 20:30 tooth gears for an 8 TPI thread, with a 40 on the spindle and 60 on the leadscrew. When you get it setup, run a scratch on some scrap and use a thread pitch gauge to see that it's right.
Reply
Thanks given by:


Messages In This Thread
zyto lathe - by billboat10 - 11-29-2015, 08:08 AM
RE: Zyto Lathe Pics - by Vinny - 12-31-2015, 04:06 PM
RE: Zyto Lathe Pics - by billboat10 - 12-31-2015, 05:22 PM
RE: zyto lathe - by DaveH - 11-29-2015, 09:31 AM
RE: zyto lathe - by ieezitin - 11-29-2015, 09:37 AM
RE: zyto lathe - by billboat10 - 12-03-2015, 04:44 PM
RE: zyto lathe - by billboat10 - 12-03-2015, 04:46 PM
RE: zyto lathe - by Sunset Machine - 12-04-2015, 09:56 AM
RE: zyto lathe - by billboat10 - 12-24-2015, 06:02 PM
zyto lathe - by billboat10 - 12-29-2015, 03:44 PM
RE: zyto lathe - by arvidj - 12-29-2015, 06:55 PM
RE: zyto lathe - by Sunset Machine - 12-30-2015, 09:31 AM
RE: zyto lathe - by Vinny - 12-30-2015, 12:49 PM
RE: zyto lathe - by billboat10 - 12-30-2015, 07:34 PM
Zyto Lathe Pics - by billboat10 - 12-31-2015, 02:31 PM
RE: zyto lathe pics - by billboat10 - 12-31-2015, 02:32 PM



Users browsing this thread: 1 Guest(s)