12-29-2015, 09:10 PM
The only reason I changed the ramp times was that the thing wasn't working. I've tried 4, 10 (default) and 15 seconds with no change. Trying the 1 1/2 HP motor only changed the error code from 2 to 4. Almost the same list.
When I changed back to the 2 HP, it actually ran the motor - then gave the Err.02 code again. Then every try was like the first.
So, am I correct in concluding that no one here has used one of these VFDs? I was hoping that someone had done it and knew some trick that the manual didn't explain very clearly. Actually, the manual that came with the unit was Chinese only. Fortunately, when I ordered the VFD, they sent a pdf English version by email.
When I changed back to the 2 HP, it actually ran the motor - then gave the Err.02 code again. Then every try was like the first.
So, am I correct in concluding that no one here has used one of these VFDs? I was hoping that someone had done it and knew some trick that the manual didn't explain very clearly. Actually, the manual that came with the unit was Chinese only. Fortunately, when I ordered the VFD, they sent a pdf English version by email.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.