12-27-2015, 02:00 PM
(12-27-2015, 09:52 AM)ieezitin Wrote: Highpower..
This face plate is wider and has more reach than my 4 jaw, that's the reason why i made them because I could not use my four jaw.
Anthony.
OK thanks Anthony. I guess I took it too literally when you mentioned extending the reach of your 4-jaw chuck. I though it was a post about modifying a 4-jaw chuck.
I have to go along with the other guys concerns as well. I bought a set of those "Mite-bite" clamps for my mill table. (The non pull-down type.) I can easily see having a heavy end mill cut pulling the part right off the table. And that is with a stationary part! Spinning the part only adds to the fun.
Willie