12-26-2015, 11:53 PM
I thought that wire was a bit thick but it's what came with the welder (note: this is one of HF's first ones, built in Italy by Hobart). Guess I'll be stopping at either home depot or HF on Monday (no time tomorrow aka Sunday).
Your first pic is what I'm talking about. The tip is about 0.092 from the tip of the nozzle (checked with my caliper).
I have a flow rate chart for the flow regulator I have matches what you say about flow rates. It's based on nozzle ID. Unfortunately I can't put it on this tank. I had borrowed a buddy's welder some time back and his had a regular regulator on it. Don't remember what it was set to.
Your first pic is what I'm talking about. The tip is about 0.092 from the tip of the nozzle (checked with my caliper).
I have a flow rate chart for the flow regulator I have matches what you say about flow rates. It's based on nozzle ID. Unfortunately I can't put it on this tank. I had borrowed a buddy's welder some time back and his had a regular regulator on it. Don't remember what it was set to.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique
the nobucks boutique etsy shop | the nobucks boutique