12-26-2015, 08:40 PM
Vinny..
One force applied from the clamping block is all thats needed.. this set up is tighter than a ducks arse. The only trick is to squeeze the job in place via a center from the tailstock.. you dont have the luxury of a movable jaw in both directions... its good for about .002 a hit.. thats really all you need.
Anthony.
One force applied from the clamping block is all thats needed.. this set up is tighter than a ducks arse. The only trick is to squeeze the job in place via a center from the tailstock.. you dont have the luxury of a movable jaw in both directions... its good for about .002 a hit.. thats really all you need.
Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.