The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › How-To's v
Face plate work holding awkward odjects

Thread Modes
Face plate work holding awkward odjects
ieezitin Offline
Sophmore
***
Posts: 205
Threads: 27
Joined: Jan 2013
Location: Maryland USA
The following 2 users Like ieezitin's post:
f350ca (12-26-2015), arvidj (12-27-2015)
#1
12-26-2015, 07:29 PM
Not my idea it came from Mr Harrold Hall. I have a project coming up that will extend the reach of my 6'' four jaw chuck  I need to hold a 6 sided object and i need it to be controlled pretty tight so i made these nice side forcing clamps.

 [Image: FACE%20PLATE%20HARROLD%20HALL%206_zpsnnjqqaa5.jpg]

Not hard to make and very useful..

[Image: FACE%20PLATE%20HARROLD%20HALL%205_zpsfxwl1e2r.jpg]


as you can see they are pretty versatile....

 [Image: FACE%20PLATE%20HARROLD%20HALL%204_zpsmwahzmnp.jpg]

[Image: FACE%20PLATE%20HARROLD%20HALL%203_zpsclyrwlie.jpg]


[Image: FACE%20PLATE%20HARROLD%20HALL%202_zpsa8vallpn.jpg]


[Image: FACE%20PLATE%20HARROLD%20HALL%202_zpsa8vallpn.jpg]

The slots in the one clamp allow the pressure to be applied perpendicular to the job via the grub screws . The other block clamps are just  buttress blocks, Align your work piece with a prick mark, center it with a carbide center, squeeze it in and clamp the piece accordingly. 

Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Face plate work holding awkward odjects - by ieezitin - 12-26-2015, 07:29 PM



Users browsing this thread: 2 Guest(s)