06-11-2012, 04:19 AM
Thanks guys. I am confident this has sorted the issue. I ran it up on the stand for a while and went through the various gears and all was good. The acid test will be when I put it back on the mill and run it under load.
However, I want to lift the table off first to check everything out, as the oiler has been broken and is another item on my to do list.
So at this point, I am placing a tick next to this on my list, knowing that I still have to test it under load in the near future.
However, I want to lift the table off first to check everything out, as the oiler has been broken and is another item on my to do list.
So at this point, I am placing a tick next to this on my list, knowing that I still have to test it under load in the near future.
Hunting American dentists since 2015.