MetalworkingFun Forum › Machinery › Other Machinery v
punch press

Thread Modes
punch press
Roadracer_Al Offline
Junior
****
Posts: 691
Threads: 14
Joined: Feb 2015
Location: Oakland, California
The following 1 user Likes Roadracer_Al's post:
Highpower (12-17-2015)
#10
12-17-2015, 01:38 PM
I have a 7" Rhodes which I almost never use, but when I do, it's usually the only tool I have which will do the job (under power, at least). I love it for keyways and square inside corners. :)

If I had room at the inn, I'd invite a Horizontal mill to visit and stay a while.
Reply
Thanks given by:


Messages In This Thread
punch press - by carkrazd - 12-10-2015, 10:55 PM
RE: punch press - by Highpower - 12-11-2015, 11:17 AM
RE: punch press - by wawoodman - 12-11-2015, 12:00 PM
RE: punch press - by carkrazd - 12-15-2015, 12:02 PM
RE: punch press - by Roadracer_Al - 12-15-2015, 02:50 PM
RE: punch press - by carkrazd - 12-15-2015, 07:35 PM
RE: punch press - by Dr Stan - 12-16-2015, 09:22 AM
RE: punch press - by Roadracer_Al - 12-16-2015, 01:07 PM
RE: punch press - by carkrazd - 12-16-2015, 01:26 PM
RE: punch press - by Roadracer_Al - 12-17-2015, 01:38 PM
RE: punch press - by carkrazd - 12-18-2015, 11:16 AM
RE: punch press - by Sunset Machine - 12-18-2015, 03:03 PM
RE: punch press - by Roadracer_Al - 12-18-2015, 07:03 PM
RE: punch press - by carkrazd - 12-19-2015, 12:17 PM



Users browsing this thread: 2 Guest(s)