Mueller Falling Block build.
#9
Well I fired up the shaper cutting my rough receiver block to size. I looked for my 2 blocks of 4140 and found the thickest one. My son took one to school in 1993 and took it to about size in the school shaper for me and I didn't find that one yet. I think its under 20 years of junk that was piled on my bench...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Mueller Falling Block build. - by aametalmaster - 12-05-2015, 05:39 PM
RE: Mueller Falling Block build. - by EdK - 12-05-2015, 05:55 PM
RE: Mueller Falling Block build. - by Highpower - 12-06-2015, 12:26 AM
RE: Mueller Falling Block build. - by Mayhem - 12-05-2015, 08:12 PM
RE: Mueller Falling Block build. - by f350ca - 12-05-2015, 08:16 PM
RE: Mueller Falling Block build. - by TomG - 12-05-2015, 10:01 PM
RE: Mueller Falling Block build. - by wawoodman - 12-06-2015, 12:54 PM
RE: Mueller Falling Block build. - by aametalmaster - 12-06-2015, 02:21 PM
RE: Mueller Falling Block build. - by JScott - 12-07-2015, 11:54 AM
RE: Mueller Falling Block build. - by Highpower - 12-10-2015, 08:45 AM
RE: Mueller Falling Block build. - by Highpower - 12-12-2015, 12:22 AM
RE: Mueller Falling Block build. - by JScott - 06-24-2016, 08:29 AM
RE: Mueller Falling Block build. - by mnovinger - 05-17-2018, 10:02 PM



Users browsing this thread: 4 Guest(s)