|
Zyto Lathe Pics
|
|
12-04-2015, 09:56 AM
(This post was last modified: 12-04-2015, 10:05 AM by Sunset Machine.)
Here's a somewhat complex spreadsheet from Conrad Hoffman that you might be able to use. The change gear section is on sheet 4. It looks like you can plug in values suitable for your lathe (leadscrew and tooth counts).
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
zyto lathe - by billboat10 - 11-29-2015, 08:08 AM
RE: Zyto Lathe Pics - by Vinny - 12-31-2015, 04:06 PM
RE: Zyto Lathe Pics - by billboat10 - 12-31-2015, 05:22 PM
RE: zyto lathe - by DaveH - 11-29-2015, 09:31 AM
RE: zyto lathe - by ieezitin - 11-29-2015, 09:37 AM
RE: zyto lathe - by billboat10 - 12-03-2015, 04:44 PM
RE: zyto lathe - by billboat10 - 12-03-2015, 04:46 PM
RE: zyto lathe - by Sunset Machine - 12-04-2015, 09:56 AM
RE: zyto lathe - by billboat10 - 12-24-2015, 06:02 PM
zyto lathe - by billboat10 - 12-29-2015, 03:44 PM
RE: zyto lathe - by arvidj - 12-29-2015, 06:55 PM
RE: zyto lathe - by Sunset Machine - 12-30-2015, 09:31 AM
RE: zyto lathe - by Vinny - 12-30-2015, 12:49 PM
RE: zyto lathe - by billboat10 - 12-30-2015, 07:34 PM
Zyto Lathe Pics - by billboat10 - 12-31-2015, 02:31 PM
RE: zyto lathe pics - by billboat10 - 12-31-2015, 02:32 PM
|
