12-02-2015, 02:39 PM
(12-01-2015, 10:26 PM)Highpower Wrote: Thanks for the links guys.
At least now I know it's "do-able". But being a typical lazy American I would want a controller that reads out in Fahrenheit so I know immediately what I'm looking at. Conversion chart? Ain't no body got time for dat!!!
I won't even get to see the furnace until next week. So I don't know exactly how big it is, or what voltage / amperage it runs on. Probably good information to have before I go ordering a controller set-up.
I don't need anything too big so I think it will be fine for me. I think any furnace will be a big improvement over using my oxy/acet torches.
buy yourself a PID controller and switch it so it reads Fahrenheit
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!