11-21-2015, 10:16 PM
Hi Greg,
My table is held on by 3 T-bolts and unfortunately it doesn't rotate like yours (I thought that your front table support looked different). Both the shaper and motor pulleys have only 4 grooves. I measured the vice and the jaws are slightly over 10 inches wide and the jaws open a full 12 inches.
Just after I bought it I read on another forum that on some shapers you can feed a shaft in from the back in order to cut a keyway, spline or ? I took a look and yes you can feed a pretty big shaft through the back. Pretty neat feature.
Sunset machine,
For me unfortunately the tool tray is kinda like my table saw. It makes a great place to pile all sorts of unrelated stuff that shouldn't be there ;)
Dave
My table is held on by 3 T-bolts and unfortunately it doesn't rotate like yours (I thought that your front table support looked different). Both the shaper and motor pulleys have only 4 grooves. I measured the vice and the jaws are slightly over 10 inches wide and the jaws open a full 12 inches.
Just after I bought it I read on another forum that on some shapers you can feed a shaft in from the back in order to cut a keyway, spline or ? I took a look and yes you can feed a pretty big shaft through the back. Pretty neat feature.
Sunset machine,
For me unfortunately the tool tray is kinda like my table saw. It makes a great place to pile all sorts of unrelated stuff that shouldn't be there ;)
Dave