MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Collets: to rack or not to rack

Thread Modes
Help Collets: to rack or not to rack
arvidj Offline
Junior
****
Posts: 736
Threads: 34
Joined: Feb 2012
Location: Minneapolis, MN
#7
11-17-2015, 08:27 PM
(11-17-2015, 10:41 AM)Dr Stan Wrote: A wooden collet rack is good, but I prefer HDPE.  Still soft enough not to damage the collets and lasts much longer than wood.

Where do you get your HDPE? When I was looking for reasonably thick pieces I was unpleasantly suprised by the price.
Reply
Thanks given by:


Messages In This Thread
Collets: to rack or not to rack - by rleete - 11-16-2015, 05:19 PM
RE: Collets: to rack or not to rack - by EdK - 11-16-2015, 05:59 PM
RE: Collets: to rack or not to rack - by Hawkeye - 11-17-2015, 01:01 AM
RE: Collets: to rack or not to rack - by Dr Stan - 11-17-2015, 10:41 AM
RE: Collets: to rack or not to rack - by arvidj - 11-17-2015, 08:27 PM
RE: Collets: to rack or not to rack - by Vinny - 11-17-2015, 09:45 PM



Users browsing this thread: 1 Guest(s)